Inhalt des Dokuments
Chemical Speciation with hard X-rays: XAFS and XES
- Figure 1: Principle of X-ray absorption and emission spectroscopy. The transmitted flux is compared to the incoming flux. This gives the energy dependent attenuation of the sample. A rise of the absorption is observable, when reaching binding energies of inner-shell electrons. Oscillations occur due to scattering of the photoelectron at neighboring atoms. The core hole can be filled with electrons from higher shells. The energy difference will be conserved by emitting a fluorescence photon, whose energy can be detected.
- © AG Kanngießer
Especially in the field of geology and catalysis there is a need for the investigation of chemical species of different kinds of samples. In this case, the chemical species means the chemical state, such as different oxidations states of the same atom (for example Fe, FeO, Fe2O3), or the orientation within a molecule.
Both properties are accessible with X-ray Emission (XES)  and Absorption fine structure (XAFS)  spectroscopy, see figure 1 for the principle of XES and XAFS. Due to the small changes in corresponding energy levels in the range of a few eV or less, the needed spectral resolving power is very high besides high requirements for the stability of the energy axis. This is the reason why these measurements are usually carried out at synchrotron radiation (SR) sources, which combine a high flux with a very good spectral resolving power up to E/delta E = 10000. That means you can resolve 0.8 eV at the energy of the copper Kα emission line duplet.
To transfer this method to the laboratory wavelength dispersive spectrometers based on the von Hamos geometry  were designed and built up, for XES [1, 5] as well as XAFS .
To ensure the necessarily high efficiency of the spectrometer due to the low brilliant laboratory sources, Highly Annealed Pyrolytic Graphite (HAPG)  [3, 7] mosaic crystals are used as the dispersive element. These crystals have the highest integral reflectivity among all known crystals and provide a spectral resolving power of up to E/delta E = 4000 in first order of reflection. Also, they promise to be usable in ultrafast x-ray absorption investigations .
With these spectrometers, it is now possible to perform high resolution XES and XAFS measurements on a laboratory scale for various applications, especially as shown in catalysis research [2, 4, 9].
Team: Jonas Baumann, Richard Gnewkow, Jonas Grage, Daniel Grötzsch, Hakim Kayed, Wolfgang Malzer, Florian Peinl, Sebastian Praetz, Christopher Schlesiger, Marcel Stuerz, Jessica Weber
Point of contact: Wolfgang Malzer , Christopher Schlesiger 
 L. Anklamm, C. Schlesiger, W. Malzer, D. Grötzsch, M. Neitzel and B. Kanngießer, Rev. Sci. Instrum. 85, 053110 (2014). Link 
 M. Dimitrakopoulou, X. Huang, J. Krohnert, D. Teschner, S. Praetz, C. Schlesiger, W. Malzer, C. Janke, E. Schwab, F. Rosowski, H. Kaiser, S. Schunk, R. Schlögl, A. Trunschke, Faraday Discuss. 208 (2018), 207–225. Link
 M. Gerlach, L. Anklamm, A. Antonov, I. Grigorieva, I. Holfelder, B. Kanngießer, H. Legall, W. Malzer, C. Schlesiger, B. Beckhoff, J. Appl. Cryst. 48 (2015), 1381-1390. Link 
 H. V. Le, S. Parishan, A. Sagaltchik, C. Goebel, C. Schlesiger, W. Malzer, A. Trunschke, R. Schomaecker, A. Thomas, ACS Catalysis 7 (2017), Nr. 2, 1403-1412. Link 
 W. Malzer, D. Grötzsch, R. Gnewkow, C. Schlesiger, F. Kowalewski, B. Van Kuiken, S. DeBeer, B. Kanngießer, Rev. Sci. Instrum. 89, 113111 (2018). Link 
 C. Schlesiger; L. Anklamm, H. Stiel, W. Malzer, B. Kanngießer, J. Anal. At. Spectrom. 30 (2015), 1080-1085. Link 
 C. Schlesiger, L. Anklamm, W. Malzer, R. Gnewkow, B. Kanngießer, J. Appl. Cryst. 50 (2017), 1490-1497. Link 
 H. Stiel; M. Schnürer; H. Legall; W. Malzer; L. Anklamm; C. Schlesiger; K. A. Janulewicz; M. Iqbal; P. V. Nickles, Proc. SPIE 8849 (2013), 88490H. Link 
 X. Zhao, P. Pachfule, S. Li, T. Langenhahn, M. Ye, C. Schlesiger, S. Praetz, J. Schmidt, A. Thomas, J. Am. Chem. Soc. 141 (16) (2019), 6623-6639. Link